TM 5-3610-287-10
2-6.
ASSEMBLY AND PREPARATION FOR USE (CONT)
Move to
1. Remove boarding ladder and handrail from cargo door.
curbside personnel door.
2.
Remove handrail from boarding ladder.
3. Mount boarding ladder (1) at curbside personnel door attachment
point (2) and secure with locking pins.
4.
Mount handrail (3) on left side of boarding ladder (1).
5. Close water tank gate valve and faucet drain petcock valve
located under sink in Section.
6.
Remove auxiliary pump (4) from shipping bracket under sink.
7.
Remove hoses and power cord from semitrailer chassis tool
box (5).
8.
Plug power cord (6) into 120 VOLT OUTLET at power entry panel.
9.
Set auxiliary pump (4) on level surface.
10 .
Connect drain hose (7) to WATER DRAIN pipe on Section body.
Connect inlet hose (8) to WATER INLET pipe on Section body.
11.
12. Connect other end of inlet hose (8) to outlet port of auxiliary
pump (4).
13. Connect water source hose (9) to inlet port of auxiliary
pump (4).
14.
Place water source hose (9) in water source.
CAUTION
Make sure auxiliary pump has been primed before
operating. Damage to shaft seal will result if
auxiliary pump is not primed.
15. Remove plug (10) from auxiliary pump (4) priming point and fill
with water. Plug in pump and continue filling with water until full.
Replace plug (10).
16.
Fill water tank until water spills out of drain hose (7).
17.
Unplug auxiliary pump (4) and power cord (6).
Inside Section, turn WATER HEATER and WATER PUMP switch to ON.
18.
2-37