Figure 2-199.
TM 5-3610-286-20
b.
Replace. (figure 2-199)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
NOTE
Wiring on the printing press is pretagged and matched to its connecting
terminal. Retag wires before replacing.
Loosen two screws (1) and open hinged cover (2).
NOTE
There are two sets of leads to run wiring to another switch.
Loosen retaining screws (3) and remove and tag leads (4) on both cables (5).
Remove two cable collars (6) and remove cables (5) from limit switch (7).
Remove two screws (8) and limit switch (7).
Replace limit switch (7) and two screws (8).
Install cables (5) into limit switch (7) and tighten cable collars (6).
Install leads (4) and tighten retaining screws (3).
Close the hinged cover (2). Tighten two screws (1).
Aline limit switch (para. c).
2-407