Figure 2-116.
(l)
(m)
(n)
(o)
(p)
TM 5-3610-286-20
Take printing press off safe and inch until socket-head screw (3) is accessible.
Tighten socket-head screw (3).
Recheck feeler gage adjustment. If too loose or too tight, repeat steps (e) through (m).
Loosen three bearing screws located under feeder table and adjust so that feeler gage
can be inserted between head stop and feeder table.
Tighten screws and adjust by performing steps (k) through (m).
NOTE
All front lays must be in a straight line. However, the two middle front lays may
be set back a little behind the other two lays. The middle front lays must not
protrude ahead of the other lays since this would make the sheet wobble and
thus cause register differences.
2-271