TM 5-3610-286-20
2-40.
Dampening Swivel Lever Assemblies.
This task covers:
a. Remove
b. Inspect
c. Repair
d. Install
INITIAL SETUP
Tools
Equipment Conditions
0.050 x 0.375 x 8 in. flat-tip screwdriver
Form dampening rollers removed
8 in. bronze punch
(TM 5-3610-286-10)
5 mm hex key
Dampening fountain assembly removed
8 mm combination wrench
(para. 2-37)
Ball-peen hammer
Main guard (D/S) removed (para. 2-20)
Retaining-ring pliers
Upper guard (O/S) removed (para. 2-18)
Dampening oscillator roller removed
(para. 2-38)
a. Remove.
NOTE
Procedures for removal and installation of dampening swivel lever assemblies
are the same for both the D/S and O/S, except for the use of a splash guard on
the D/S.
(1) Splash guard. (figure 2-81). Remove cap screw (1), washer (2), and splash guard (3)
from D/S swivel lever assembly.
2-204