TM 5-3610-286-20
2-22.
Manual Inking Roller Assembly (cont).
b. Repair.
(1) Manual inking roller. Replace worn or gouged roller.
(2) Manual inking roller assembly. (figure 2-27)
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
Remove pins (1) and inking roller (2).
Slide roller support levers (3) off of mounting bar (4).
Loosen hex nuts (5) and unscrew handles (6).
Remove four socket-head screws (7), four hex nuts (8), eight washers (9), two clamps
(10), and guard (11).
Hammer out deformed guard. Replace worn or gouged roller.
Replace guard (11) on mounting bar (4).
Aline clamp (10) holes with holes in guard (11).
Replace four socket-head screws (7), eight washers (9), and four hex nuts (8).
Replace handles (6) and hex nuts (5) in roller support levers (3) and tighten hex
nuts (5).
Slide roller supports (3) onto mounting bar (4).
Insert roller shaft at each end of roller (2) into support levers (3) and replace pins (1).
2-94