TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
c.
Prepare Cylinder Assembly (Cont)
(g)
tail clamp
(h)
with plate
(i)
scopes (3)
(j)
Put Printing Press on safe.
Insert tail edge of plate into
(1).
Ensure plate is seated against pins (2) and lock tail clamp (1)
wrench.
Take Printing Press off safe and inch forward until register
are visible.
Put Printing Press on safe.
Starting at center, tighten
gripper clamp tension nuts (4) until register scopes (3) are alined with
holes in plate.
(k) Using wrench, tighten tail clamp tension nuts (5) until plate
is tight around cylinder.
(1) Check plate tension on cylinder by tapping plate near cylinder
end with knuckle.
(m) Tighten gripper clamp tension nuts (4).
2-63