TM 5-3610-286-10
2-7.
e.
OPERATING PROCEDURES (CONT)
Prepare Inking Assembly (Cent)
Two people are required to perform next step.
(d) As first person holds operator side stub shaft, second person
inserts oscillator roller no. 5 evenly into stub shafts.
(e) Insert special wrench into operator side frame opening. Engage
wrench in slot and turn to right until roller stops.
(f) Ensure open end of stub shafts completely penetrate oscillator
roller no. 5 from both sides.
(8) Install Form Roller No. 4 (Yellow)
(a) Loosen knurled locking nut (1).
(b) Push safety sleeve (2) completely in. Grasp knurled locking
nut (1) and pull journal shaft (3) outward.
(c) Insert form roller no. 4 bearing into retracted journal on
operator side.
(d) Aline opposite roller bearing and slide roller bearing into
gear side journal.
2-81