TM 5-3610-285-14
f.
Holding tape taut, apply it perpendicular to panel skin. Do not apply with rolling motion either end-to-end or
center-to-ends. Do not rub each strip in place individually. Apply all strips lightly with proper overlap and rub into
place.
g.
If necessary, damaged tape can be replaced; however, it should be removed with careful peeling motion to avoid
damage to sealant. If sealant also peels back, new sealant should be applied. Complete removal of old sealant
is not necessary. Permanent repair by direct support or higher category of maintenance should be made as soon
as possible.
1-16.14. Replace Tiedown Socket.
MOS: 83FJ6, Reproduction Equipment Repairer
or
41B, Topographic Instrument Repair Specialist
TOOLS:
Tool Kit, Light Machine Repair
Cross Tip Screwdriver
Flat Tip Screwdriver
SUPPLIES: Tiedown Socket
a.
Remove screws from tiedown socket.
b.
Pry defective socket from floor.
c.
Install new tiedown socket. Rotate new tiedown socket enough to avoid installing screws in old screw holes.
d.
Reinstall screws.
1-79