TM 5-3610-285-14
7-6.
OPERATION UNDER USUAL CONDITIONS.
7-6.1
Assembly and Preparation for Use.
CAUTION
Be sure correct voltage is selected prior to applying power or serious damage to equipment may occur.
a.
Be sure voltage selection switch on rear panel is set to correct position for power available.
b.
Plug in light table and densitometer power cord.
c.
Plug in reflection/transmission probe cable.
NOTE
For the highest possible accuracy, the densitometer should be turned on and allowed to reach normal
operating temperature (one half hour or more) before use.
d.
Set POWER switch on densitometer and light table to ON position.
e.
Be sure digital display, light table lamps, transmission probe lamp, and reflection probe lamp light.
7-14