TM 5-3610-285-14
c.
Remove two screws and lower switch panel cover.
d.
Remove four mounting screws, flat washers, and lockwashers. Carefully remove power supply from switch panel
with wiring attached.
e.
Tag and desolder two wires at transformer terminals. Remove wires and strain relief bushing from chassis.
f.
Loosen two screws on bottom of power supply chassis; tag and remove two wires. Remove defective power
supply.
g.
Connect wires at bottom of new power supply chassis, and secure with two screws.
h.
Install two wires through strain relief and aperture in chassis. Solder to transformer terminals.
i.
Firmly seat strain relief in power supply chassis.
j.
Install new 12 volt power supply in switch panel and secure with four screws, flat washers and lockwashers.
k.
Close switch panel cover and secure with two screws.
l.
Replace chiller on chiller base and secure with straps.
m.
Turn on CB7 on van's circuit breaker panel.
5-177