TM 5-3610-253-14
(4) Turn Star-Delta switch to Y position. After main motor is at full
speed, turn switch to
position.
(5) Press control power on switch.
b. Move backgauge forward or backward as required until backgauge position
is displayed on measurement display.
WARNING
Electrical shock hazard. You must stand on rubber matting as a protective
measure before performing this procedure. Death or serious injury may
occur.
Remove side covers on both light barri er housings.
c.
d. Connect multimeter to pins in connector plug for receiver being
adjusted.
e.
Voltage reading should be 150 millivolts minimum.
f. If voltage is less than 150 millivolts, proceed to step h.
Repeat steps d through f for remaining receivers. If this was the last
g.
receiver, proceed to step i.
h. Adjust emitter and/or receiver as follows:
5-638