TM 5-2330-305-14
2. Tag and loosen connectors and remove two air hoses from valve.
3. Remove bolt and nut which retains linkage to valve arm.
4.
Remove two bolts, nuts and washers retaining valve to bracket and
remove valve.
5. Install new valve to bracket and retain with bolts, nuts and
washers.
6. Reinstall linkage and retain with bolt, nut and washers.
7. Reinstall air hoses with thread sealant and tighten connectors
securely.
8. Turn manual override valve selector switch to OFF.
NOTE
Allow approximately see for air
to start flowing through valve
due to built-in-time delay.
9. Loosen adjustment screw and move nylon block(up or down until
desired frame-to-axle height is achieved (4.4.1.23)
10. Tighten adjustment screw securely.
11. Check fittings for leaks by applying soapy water solution and in-
specting for presence of bubbles.
4-47